Command Classic/PCB

PCBs for the Command Classic do not yet exist. This page tracks efforts to design and produce some.

Common Goals

• The PCB should not be used for structural support (gasket mount, etc). It should be usable in any cases that rely on a connection between the switch plate and the case.
• Use Unified Daughterboard C Series to avoid dependency on specific cases
  • New C4 design uses Pico-EZmate connectors instead of JST SH
  • Consider using JST SH for now because vendor stock is still mostly pre-C4

Standard

TBD

Compact

• Current goal is to use TOFU60 2.0 cases (though this should not affect the PCB design]